Build Your Own Custom Kit

All boats are not the same and the variety of engine configurations and engine options are many.
This is where you can build your own kit. Simply by counting the number of drain ports on all of the equipment on the boat (see examples 1 and 2), you can order your custom kit on this web site.
If you are not sure - ask a marine mechanic to help identify the drain ports on your boat.

Example 1:  42 ft. 89 Chriscraft

Two V6 engines with power steering, transmission cooler and water heater. Each engine should have 4 drain ports, one on each side of the block and one on each exhaust manifold. The power steering on some boats have a separate cooler that has one drain port. The transmission cooler should have one drain port and the water heater should have a drain port.

• total drain ports - 11
• total barb fittings - 11
• total sand traps - 11
• total filters - 11
• total male quick connects - 11
• total mounting brackets - 3  (one three hole, two four hole or any other combination)
• one female quick connect
• one pump
• hose - measure the distance from the drain ports to the mounting brackets (we used 30 ft.)
 
Original time to drain engines, cooler and heater  -  never drained the system.
With the sea-flush kit  -  less then 12 min. with no mess and the ability to recover all the salt neutralizers for reuse.
 
Order the parts to build your own custom kit from the Sea-Flush Store and we will send your custom kit ASAP.

 
Example 2 -  28 ft sail boat

A single cylinder engine which has one drain port, bilge and a standby generator with one drain port.

• total drain ports - 3
• total sand traps - 3
• total barb fittings - 3
• bilge drain (a hose just goes to the bottom of the hull)
• total filters - 3
• total male quick connects - 3
• bracket - 1 (3 hole flat)
• one female quick connect
• one pump
• hose - measure the distance from the drain ports to the mounting brackets (we used 10 ft)
 
Original time to drain engine, generator - never drain the system.
With the sea-flush kit -  less then 5 min. and no mess as well as the ability to recovery all of the salt neutralizers for reuse.
 
Order the parts to build your own custom kit from the Sea-Flush Store and we will send your custom kit ASAP.
 
Picture below shows the connection to each drain port



 

please note that the sea-flush system is the same as the winterizer system – thewinterizer.com